Bank Shots vs Kick Shots: Where Do the Diamond Numbers Actually Help?
Players often lump banks and kicks together as "rail shots", and the diamond systems get sold as the answer to both. They are not the same problem. A diamond system is very good at one of them and only loosely useful for the other. Knowing which is which saves a lot of frustration, and it tells you when to reach for our Diamond System Calculator and when to rely on a different method.
What is the difference between a bank and a kick?
- A bank shot sends the object ball into one or more cushions and then into a pocket. You strike the cue ball, the cue ball strikes the object ball, and the object ball does the rail work.
- A kick shot sends the cue ball into one or more cushions before it reaches the object ball. Kicks are how you escape a snooker, and sometimes how you pocket a ball you cannot see directly.
The difference that matters is which ball travels round the rails. In a kick it is the cue ball, the ball you hit directly with the cue. In a bank it is the object ball, which you only control second-hand.
Why do diamond systems suit kicks better?
A diamond system is a promise about how a ball behaves after a known stroke: struck at a set speed, with set spin, it will come off the cushions along a predictable track. With the cue ball you can deliver that stroke. You choose the speed, you put on the running english the corner-5 system expects, and you can make the cue ball roll rather than slide into the first rail. Do that consistently and the numbers repeat.
With the object ball you cannot. The object ball takes whatever the collision gives it: its speed depends on how full you hit it, it picks up a little spin from the cut angle, and it is pushed slightly off line by friction between the balls (usually called throw). None of that is something a system can number, because it changes with every cut angle and speed. So the diamond systems that work best are the cue-ball ones.
How does the corner-5 system handle a three-rail kick?
Corner-5 handles the classic three-rail kick: first long rail, far short rail, back up the other long rail. The arithmetic is origin minus target equals aim. Two quick cases from the calculator:
- Cue ball near a corner (origin 5), object ball sitting on the third rail at 2.5: aim at first-rail 2.5. This is also the benchmark shot many pool tables play close to.
- Cue ball whose line runs back to the short rail at 6, object ball at third-rail 3: aim at 3.
The full method, including how to read the origin by sighting through the cue ball, is in our corner-5 walk-through. The short version is that the subtraction is easy and reading the origin is the skill.
What about one-rail and two-rail kicks?
For a one-rail kick, mirror aiming is simpler and more accurate than any numbered system. Imagine the table reflected in the cushion you are kicking off, find where the object ball would sit in that reflection, and shoot straight at the reflected ball. The one refinement is that the reflection should be taken about the line the center of the cue ball travels along when it touches the cushion, which sits half a ball's width off the cushion nose, rather than about the cushion nose itself. On most tables you also allow for the cue ball coming off a little shorter than a perfect reflection at firm speed.
Diamonds help here as a measuring tool rather than a system. On a 9-foot table they are 12.5 inches apart, on an 8-foot table 11 inches, on a 7-foot bar box 9.75 inches. Counting diamonds lets you check your mirror point: if the object ball sits two diamonds off the rail, its reflection sits two diamonds behind the rail, and you can sight on that.
Two-rail kicks have their own numbered systems, but they are outside what our calculator covers. If you use one, the same caution applies as with corner-5: calibrate it on your own table before you rely on it in a match.
Can diamonds help with bank shots at all?
Yes, as geometry. The same mirror idea gives you a first estimate for a one-rail bank: reflect the pocket in the cushion line and aim the object ball at that reflected pocket. A useful special case: if the object ball and the pocket are the same distance from the cushion you are banking off, the object ball should strike that cushion halfway between them along the rail. Diamonds make "halfway" easy to find.
Then expect to adjust, because banks do not reflect perfectly. A few tendencies most players notice:
- Speed shortens banks. Hit firmly and the object ball tends to come off the cushion at a narrower angle than the mirror suggests. Slow banks tend to run a little longer.
- The cut adds spin. Cutting the object ball gives it a little side spin, which changes its rebound. Thin cuts and full hits bank differently.
- Throw moves the start line. On a cut bank the object ball leaves slightly off the line you aimed, so the error starts before the ball reaches the rail.
None of these is easy to put in a formula, which is why good bank players tend to learn by feel and pattern rather than by system.
When should you choose a kick over a bank?
When you are snookered, the choice is made for you. When you are not, compare the two honestly:
- A bank risks one thing: the object ball missing the pocket. If it misses, the object ball is often left near a rail, and your opponent may have an easy shot.
- A kick to pocket a ball adds a second uncertainty, because the cue ball must reach the object ball accurately before the object ball can go anywhere.
- A kick to make a legal hit is different. Hitting a ball is far easier than pocketing it. When the goal is only contact plus a cushion, a calculated kick is usually the safest option on the table. Our guide to kicking out of a snooker covers that case.
A drill that separates the two skills
Because the two shots fail for different reasons, practice them separately.
- Kick drill. Put an object ball against the third rail at 2.5 and freeze the cue ball near the opposite corner. Using the calculator's aim of 2.5, kick ten times at the same medium speed with running english. Count hits. Then move the object ball to 2, where the aim becomes 3, and to 3, where it becomes 2. If you consistently land on the same side of the ball, that is your table's offset, not bad luck.
- Bank drill. Place an object ball one diamond off the long rail opposite a side pocket and bank it cross-side ten times at three speeds: soft, medium and firm. Note how the firm ones come off shorter. Then repeat with a slight cut, first one way, then the other.
After a couple of sessions you will have two separate notes: the offset that turns calculator aims into real aims on your table, and a feel for how your banks shorten with speed. They are different numbers, and treating them separately is the point.
Summary
- Kicks move the cue ball, which you control, so a diamond system can describe them. Use corner-5 for three-rail kicks and mirror aiming for one-rail kicks.
- Banks move the object ball, which picks up throw, spin and speed you only partly control. Use the mirror as a starting point and correct for speed and cut.
- The calculator covers the corner-5 arithmetic only. It is a starting point to adjust from, not a guarantee.