How Do You Kick Out of a Snooker? Using Corner-5 Numbers When You Are Hooked
Safety play works because it leaves the other player without a clear shot. Sooner or later you are on the wrong end of it: the ball you must hit is hidden behind others, and the only routes to it go off the cushions. Fouling here usually hands your opponent ball in hand, which in nine-ball or eight-ball is often the rack. A planned kick does not have to pocket anything. It has to make a legal hit and, ideally, leave something awkward behind. This guide shows how to plan a three-rail escape with corner-5 numbers and our Diamond System Calculator, and how much accuracy you actually need.
What does a legal kick have to do?
Rules vary between leagues, so check yours, but under the widely used World Pool-Billiard Association rules for eight-ball and nine-ball a legal shot must do two things:
- The cue ball must first contact a ball you are allowed to hit (in nine-ball, the lowest-numbered ball on the table; in eight-ball, one of your group).
- After that contact, either a ball must be pocketed, or the cue ball or some object ball must reach a cushion.
The important detail for kicks: the cushions the cue ball hits before reaching the object ball do not satisfy the second requirement. A perfect three-rail kick that brushes the object ball and stops dead, with nothing going to a rail afterward, is still a foul. Plan for the contact and for what happens after it.
How big is the target on a kick?
Bigger than it looks. A pool ball is 2.25 inches across, and the cue ball touches the object ball whenever their centers pass within one ball's width of each other. So the window the cue ball's center has to pass through is two ball widths, 4.5 inches, wide.
Translate that into diamonds and it becomes clearer how much error you can afford on the third rail:
- On a 9-foot table, diamonds are 12.5 inches apart, so the window is about 0.36 of a diamond: roughly 0.18 either side of dead center.
- On an 8-foot table (11-inch spacing), about 0.41 of a diamond.
- On a 7-foot bar box (9.75-inch spacing), about 0.46 of a diamond.
That is for a ball sitting right on the cue ball's path near a rail. It is a generous target compared with pocketing a ball, but it is smaller than the error an uncalibrated table produces. If your table plays half a diamond long, an aim taken straight from the system misses the window entirely. Calibrating first is not optional for kicks that matter; see calibrating the diamond system to your table.
Worked example: the object ball near the third rail
The cue ball is near a corner, so the line of a three-rail kick comes out of the corner and the origin is 5. The ball you must hit is frozen to the opposite long rail at third-rail diamond 3. The calculator, given origin 5 and target 3, returns an aim of 2.
Now apply what you know about the table. Suppose your benchmark kicks earlier in the session landed an average of 0.5 of a diamond long. You would add that and aim correspondingly higher than 2. Without the correction, a 0.5-diamond error on a 9-foot table is about 6.25 inches, compared with a hit window only 0.36 of a diamond across. The kick would miss.
Speed matters too. Then think about the after-contact rule. Most rule sets do not count a ball already frozen to a cushion as having reached it just because it was hit, so after contact the cue ball or another ball still has to get to a rail. A cue ball arriving along the rail often touches the cushion again, but give the shot enough speed to be sure. Too firm, though, and the cue ball crosses the table and may leave your opponent an open shot.
Worked example: a ball out in the table
The object ball sits a diamond out from the third rail. Your three-rail path still crosses the line of that ball, just before the cue ball reaches the rail. You can aim the track to arrive on the rail a little beyond the ball, so that the cue ball meets the ball on its way in. If the track reaches the third rail at 2.5 and the ball sits just short of that, choose 2.5 as the target. From origin 5, the aim is 2.5; from an origin of 5.5, it is 3.
The after-contact rule is harder here. The object ball is out in the open, so a thin hit might send nothing to a rail. Prefer a fuller hit that drives the object ball toward a cushion, and give the cue ball enough speed to finish its own journey to a rail as insurance.
Choosing which kick to take
Often there is more than one route. A one-rail kick with mirror aiming, a two-rail kick, a three-rail kick by the numbers. Some questions to choose between them:
- Which route has the widest effective target? A route that meets the object ball square on is safer than one that has to clip its edge.
- Which route avoids other balls? A three-rail track crosses most of the table; check every ball along the way.
- Which aim sits away from pockets? On the first rail, 4 is the side pocket and 0 and 8 are corners. If the calculator's aim lands on one, it will flag it; look for another route or another origin.
- Where does each route leave the cue ball? A legal hit that leaves an easy shot is better than a foul, but worse than a legal hit that leaves a hard one.
- Which do you shoot better? A one-rail kick you have practiced beats a three-rail kick you have read about.
What happens if you foul anyway?
Sometimes no route is likely to work. Then the question becomes which foul hurts least. In rule sets where any foul gives ball in hand, it can be better to make a solid attempt that, if it misses, at least moves the cue ball somewhere awkward than to play a timid kick that misses and leaves an easy table. Check your league's rules on intentional fouls and on what counts as a good hit before planning around this.
Practice routine for kicking out
- Place an object ball on the third rail at 2, 2.5 and 3 in turn. Freeze the cue ball near the opposite corner.
- Use the calculator's aims: 3, 2.5 and 2.
- Shoot five at each with your calibrated stroke. Count legal hits only: contact first, then a ball to a rail.
- Repeat with the object ball a diamond off the rail, so that the after-contact rule makes you think about speed.
Keep the counts. They tell you which kicks you can rely on in a match and which ones need more work.
Common questions
Is it better to kick with speed or softly?
The corner-5 numbers assume medium speed, so start there. A very soft kick may not make it round three rails, and a very hard one changes the rebound angles and scatters the balls after contact. Choose the softest speed that still sends a ball to a cushion after the hit with some margin.
Should I aim for the center of the object ball?
Usually aim the track to meet the ball as fully as possible, because that uses the whole two-ball-wide window and gives the most control over where the object ball goes. If one side of the ball is blocked by another ball, aim for the open side and accept a thinner hit.
Does the system work for a ball in the corner pocket jaws?
Yes, and it is one of its best uses. On many tables the benchmark track, origin minus aim equal to 2.5, runs on toward the corner at the starting end, so a ball hanging there can often be kicked in. Calibrate first, because a ball in the jaws leaves little margin.
What the numbers cannot tell you
- The calculator gives the corner-5 subtraction. It does not read the origin, choose the speed, or know your table.
- Rules differ between leagues and events; this is not a rules ruling. When it matters, ask the referee or league official before you shoot.
- No kicking system turns a hard hook into an easy shot. It turns a guess into a plan you can measure and improve.
For the basics of reading the numbers, see how the corner-5 system works, then use the Diamond System Calculator to check your aims.